Jeep Liberty: Headlights With Wipers (Available With Automatic Headlights Only) - Windshield Wipers And Washers - Understanding The Features Of Your Vehicle - Jeep Liberty Owner's ManualJeep Liberty: Headlights With Wipers (Available With Automatic Headlights Only)

When this feature is active, the headlights will turn on approximately 10 seconds after the wipers are turned on if the multifunction lever (on the left side of the steering column) is placed in the AUTO position. In addition, the headlights will turn off when the wipers are turned off if they were turned on by this feature.

The Headlights with Wipers feature can be turned on or off through the Electronic Vehicle Information Center (EVIC) — if equipped. Refer to “Electronic Vehicle Information Center (EVIC)/Personal Settings (Customer- Programmable Features)” in “Understanding Your Instrument Panel” for further information.

    Rain Sensing Wipers — If Equipped
    This feature senses moisture on the windshield and automatically activates the wipers for the driver. This feature is especially useful for road splash or overspray from the windshield washers o ...

    Tilt Steering Column
    This feature allows you to tilt the steering column upward or downward. The tilt control handle is located below the steering wheel at the end of the steering column. Tilt Steering Control Ha ...

    See also:

    Taking out the spare tire (vehicles without the spare tire cover)
    Using the wheel nut wrench, loosen the hold-down nuts by turning them counterclockwise until they can be loosened by hand. Follow the order shown in the illustration. 2 Remove all the wheel nu ...

    Indicators for operation
    The design of the warnings and alerts may differ depending on the model. 1. Door open warning This warning appears if any of the doors are open or not closed securely. The vehicle icon indic ...

    Attaching the towing eyelet
    1 The towing eyelet is located under the floor of the cargo area, with the spare tire and may be partially concealed. This eyelet must be screwed into the positions provided on the right sides ...