Mitsubishi Outlander: Tools and jack
Storage
The tools and jack are stowed on the right side of the luggage area. The storage location of the tools and jack should be remembered in case of an emergency.
1- Jack. 2- Tools.
Tools
1- Tool case. 2- Wheel nut wrench. 3- Jack bar. 4- Towing hook.
Jack
To remove
1. Turn the knob (A) anticlockwise and remove the lid (B).
2. Remove the fastening band (C) and remove the tools.
3. Retract the jack and remove it from its installation fitting (D).
To store
1. Retract the jack, then return it to its original position. 2. Extend the jack and firmly secure it.
3. Return the tools to the tool bag, return it to its original position, and firmly fasten with the fastening band. 4. Install the lid and turn the knob clockwise.
Engine overheating
When the engine has overheated, the information screen in the multi-information display will be interrupted and the engine coolant temperature warning display will appear. The screen will then cha ...How to change a tyre
Before changing a tyre, first stop your vehicle in a safe, flat location. 1. Park the vehicle on level and stable ground, free of loose pebbles, etc.. 2. Set the parking brake firmly. 3. Turn the ...See also:
SmartKey
0 To remove the SmartKey (shift the transmission to position P)
1 Power supply for some consumers, such as the windshield wipers
2 Ignition (power supply for all consumers) and drive position
3 T ...
Bulb Replacement
For the proper type of replacement bulbs, see Replacement Bulbs on page 10‑37.
For any bulb changing procedure not listed in this section, contact your dealer. ...
Tpm system messages
When a problem is detected, the warning lamp
will illuminate or flash. A text message will be
displayed. Until the fault is rectified, the
warnings will be repeated each time the
ignition is switc ...