Dodge Nitro: Tilt steering column - Understanding the features of your vehicle - Dodge Nitro Owner's ManualDodge Nitro: Tilt steering column

This feature allows you to tilt the steering column upward or downward. The tilt lever is located on the steering column, below the turn signal lever.

Push the lever down to unlock the steering column. With one hand firmly on the steering wheel, move the steering column up or down, as desired. Pull the lever up to lock the column firmly in place.

Tilt Steering Control Handle Tilt Steering Control Handle

WARNING: Do not adjust the steering column while driving. Adjusting the steering column while driving or driving with the steering column unlocked, could cause the driver to lose control of the vehicle. Be sure the steering column is locked before driving your vehicle. Failure to follow this warning may result in serious injury or death.

    Windshield wipers and washers
    The windshield wiper/washer control lever is located on the right side of the steering column. The front wipers are operated by rotating a switch, located at the end of the lever. For informatio ...

    Electronic speed control
    When engaged, the Electronic Speed Control takes over the accelerator operation at speeds greater than 25 mph (40 km/h). The Electronic Speed Control lever is located on the right side of the s ...

    See also:

    Under-floor storage compartment (if equipped)
    Under-floor storage compartment (if equipped) The storage compartment is located under the floor of the cargo area, and it can be used to store small items. To open the lid, pull the tab up ...

    Parking lamp/standing lamp
    Switch off the lights. Open the hood. Remove the headlamp cover (). Left-hand headlamp: detach the washer fluid reservoir (). Turn housing cover 1 counter-clockwise and pull it out. Pul ...

    Dimensions and weights
    *1: Without spare tire *2: 215/70R16 tires *3: 225/65R17 tires *4: 235/55R18 tires *5: With spare tire cover *6: Unladen vehicle *7: With third seats *8: With towing package ...