Subaru Forester: Selecting turn signal lights operation
When the remote keyless entry system is used, the turn signal lights flash. However, the turn signal lights flashing operational non-operational setting can be changed.
Models with genuine SUBARU navigation system:
The setting can be changed using the navigation monitor. For details, refer to the Owner’s Manual Supplement for the navigation system.
Models without genuine SUBARU navigation system:
The setting can be changed by your SUBARU dealer. Contact your SUBARU dealer for details.
Sounding a panic alarm
Sounding a panic alarm A “PANIC” button is located on the back of the transmitter. To activate the alarm, press the “PANIC” button once. The horn will sound and the turn signal ligh ...Selecting audible signal operation
Using an electronic chirp, the system will give you an audible signal when the doors lock and unlock. If desired, you may turn the audible signal off. Do the following to deactivate the audible ...See also:
Engine Block Heater — If Equipped
The engine block heater warms the engine, and permits
quicker starts in cold weather. Connect the cord to a
standard 110-115 Volt AC electrical outlet with a
grounded three-wire extension cord.
...
Centrally locking and unlocking the vehicle from the inside
You can centrally lock or unlock the vehicle from the inside.
The central locking/unlocking button does not lock or unlock the fuel filler
flap.
You cannot unlock the vehicle centrally from the ...
Operating tips
- The screen displayed on the Around View
Monitor will automatically return to the
previous screen when no operation takes
place for 3 minutes after the CAMERA
button has been pushed while the ...