Jeep Liberty: Redial
• Press the button to begin.
• After the “Ready” prompt and the following beep, say “Redial”.
• The Uconnect™ Phone will call the last number that was dialed from your mobile phone.
NOTE: This may not be the last number dialed from the Uconnect™ Phone.
Call Termination
To end a call in progress, momentarily press the
button. Only the active call(s) will be terminated and if
there is a call on hold, it will become the new active call.
If the active call is ter ...
Call Continuation
Call continuation is the progression of a phone call on the
Uconnect™ Phone after the vehicle ignition key has been
switched to OFF. Call continuation functionality available
on the vehicle ca ...
See also:
Hazard warning flasher switch
Hazard warning flasher switch
Push the switch on to warn other drivers when
you must stop or park under emergency conditions.
All turn signal lights will flash.
- If stopping for an emergen ...
Rolling re-start
If the engine is switched off while the vehicle is
moving, a rolling re-start can be initiated.
Automatic transmission - select neutral (N) and
then press the engine START/STOP button.
When the en ...
Safety Canopy System
WARNING: Do not place
objects or mount equipment
on or near the headliner at the
siderail that may come into
contact with a deploying Safety
Canopy . Failure to follow these
instructions may in ...