Subaru Forester: Heater operation
NOTE
- Models with air conditioner system:
When the “” or “”
position is
selected, the air conditioner compressor
automatically operates regardless
of the position of the air conditioner
button to defog the windshield more
quickly. At the same time, the air inlet
selection is automatically switched to
the OFF position (outside air). However,
the air conditioner indicator light
does not illuminate at this time.
- When defrosting, defogging or heating, warm air is also emitted from the right and left air outlets. To stop warm airflow from these outlets, turn the corresponding thumb wheel down.
Air inlet selection button
Air inlet selection button ON position (Recirculation): Interior air is recirculated inside the vehicle. Push the air inlet selection button to the ON position. The indicator light will illu ...Defrosting or defogging the windshield
Defrosting or defogging the windshield To direct warm air to the windshield and front door windows: 1. Set the airflow control dial to the “” position. 2. Turn the temperature control ...See also:
High-Beam On Light
The high&-beam on light comes on when the high-beam headlamps are in use.
See Headlamp High/Low-Beam Changer on page 6‑2 for more information. ...
What to Add
Use only new DOT 3 brake fluid from a sealed container. See Recommended Fluids
and Lubricants on page 11‑12.
Always clean the brake fluid reservoir cap and the area around the cap before
re ...
Parking on a grade
Always block the wheels under both
vehicle and trailer when parking. Apply
the parking brake firmly. You should not
park on a hill or slope. But if parking on a
hill or slope cannot be avoided ...