Nissan Rogue: Headlight aiming control (if so equipped) - Headlight switch - Headlight and turn signal switch - Instruments and controls - Nissan Rogue Owner's ManualNissan Rogue: Headlight aiming control (if so equipped)

Headlight aiming control (if so equipped)
Headlight aiming control (if so equipped)

Depending on the number of occupants in the vehicle and the load it is carrying, the headlight axis may be higher than desired. If the vehicle is traveling on a hilly road, the headlights may directly hit the rearview mirror of the vehicle ahead or the windshield of the oncoming vehicle. The light axis can be lowered with the operation of the switch.

The larger the number designated on the switch, the lower the axis.

When traveling with no heavy load or on a flat road, select position 0.

Xenon headlights are extremely bright

Xenon headlights are extremely bright compared to conventional headlights. If the xenon headlights hit the rearview mirror of the vehicle ahead or the windshield of oncoming vehicle, the driver of these vehicles may have difficulty driving because of the brightness.

Use the headlight aiming control switch to lower the light axis. See “Xenon headlights” earlier in this section for additional information.

    Battery saver system
    - When the headlight switch is in the or position while the ignition switch is in the ON position, the lights will automatically turn off 5 minutes after the ignition switch has been turned ...

    Daytime running light system (Canada only)
    The daytime running lights automatically illuminate when the engine is started with the parking brake released. The daytime running lights operate with the headlight switch in the OFF position ...

    See also:

    Towing Requirements
    To promote proper break-in of your new vehicle drivetrain components, the following guidelines are recommended: CAUTION! • Do not tow a trailer at all during the first 500 miles (805 km) the ...

    Braking System Design
    The hydraulic system that operates the brakes has two separate circuits. Each circuit works diagonally across the vehicle (the left-front brake is connected with the right-rear brake, etc.). ...

    Trip computer "From start" or "From reset"
    The values in the From start submenu are calculated from the start of a journey, while the values in the From Reset submenu are calculated from the last time the submenu was reset (). Press th ...