Nissan Rogue: Daytime running light system (Canada only) - Headlight switch - Headlight and turn signal switch - Instruments and controls - Nissan Rogue Owner's ManualNissan Rogue: Daytime running light system (Canada only)

The daytime running lights automatically illuminate when the engine is started with the parking brake released. The daytime running lights operate with the headlight switch in the OFF position or in the switch to the  position for full illumination position. Turn the headlight switch to the when driving at night. position for full illumination when driving at night.

If the parking brake is applied before the engine is started, the daytime running lights do not illuminate. The daytime running lights illuminate once the parking brake is released. The daytime running lights will remain on until the ignition switch is turned to the OFF position.

When the daytime running light system

When the daytime running light system is active, tail lights on your vehicle are not on. It is necessary at dusk to turn on your headlights. Failure to do so could cause an accident injuring yourself and others.

    Headlight aiming control (if so equipped)
    Headlight aiming control (if so equipped) Depending on the number of occupants in the vehicle and the load it is carrying, the headlight axis may be higher than desired. If the vehicle is tra ...

    Turn signal switch
    1 Turn signal Move the lever up or down to signal the turning direction. When the turn is completed, the turn signals cancel automatically. 2 Lane change signal To indicate a lane change, mov ...

    See also:

    Interior overview
    1. Door lock/unlock button 2. Power window switches 3. Outside rearview mirror control switch (if equipped) 4. Hood release lever 5. Instrument panel illumination (if equipped) 6. Electronic st ...

    Engine Coolant Check
    Look at the coolant level in the radiator reserve tank. Make sure it is between the MAX and MIN lines. If it is below the MIN line, see Adding Engine Coolant on page for information on add ...

    Shifting Procedures
    NOTE: If any of the requirements to select a new transfer case position have not been met, the transfer case will not shift, the indicator light for the previous position will remain on, and the ...