Volvo XC60: Deactivation
Move the gear selector from R to another position.
There is a slight delay in the PAC system, which means that the view from behind the vehicle will remain on the screen for approximately 15 seconds after the gear selector has been moved from the R position or until the vehicle reaches a forward speed of 6 mph (10 km/h). The screen will then revert to the mode that it was in before R was selected and will, for example, display navigation system information.
NOTE
If any button on the center console control
panel is pressed, the camera image will disappear
from the display. Pressing CAM will
return the camera image to the display.
Zoom
The camera can be useful when attaching a trailer. Press CAM to zoom in on the trailer hitch (and press this button again to return to the normal camera view). With the camera zoomed in on the ...Guiding lines
The lines on the screen are projected as if they were a path on the ground behind the vehicle and are affected by the way in which the steering wheel is turned. This enables the driver to se ...See also:
Viewing range on the screen
Range of view
Range of view
Image from camera
The area from the rear end of the bumper
can be viewed. Areas at both ends of the
bumper and areas just under the bumper
cannot be vi ...
Preparing to drive
You should perform the following checks
and adjustments every day before you
start driving.
1. Check that all windows, mirrors, and
lights are clean and unobstructed.
2. Check the appearance a ...
Setting the airflow
Turn the SmartKey to position 2 in the ignition lock.
To increase/reduce: press the
or
button.
...