Jeep Liberty: Recreational Towing — Four-Wheel Drive Models - Recreational Towing (Behind Motorhome, Etc.) - Starting And Operating - Jeep Liberty Owner's ManualJeep Liberty: Recreational Towing — Four-Wheel Drive Models

The transfer case must be shifted into NEUTRAL (N) and the transmission must be placed in PARK for recreational towing. The NEUTRAL (N) selection button is adjacent to the transfer case selector switch. Shifts into and out of transfer case NEUTRAL (N) can take place with the selector switch in any mode position.

CAUTION!
• Front or rear wheel lifts should not be used.

Internal damage to the transmission or transfer case will occur if a front or rear wheel lift is used when recreational towing.

• Tow only in a forward direction. Towing this vehicle backwards can cause severe damage to the transfer case.

• The transmission must be placed in PARK for recreational towing.

• Before recreational towing, perform the procedure outlined under “Shifting into NEUTRAL (N)” to be certain that the transfer case is fully in NEUTRAL (N). Otherwise, internal damage will result.

• Failure to follow these procedures can cause severe transmission and/or transfer case damage.

• Do not use a bumper-mounted clamp-on tow bar on your vehicle. The bumper face bar will be damaged.

Recreational Towing — Two-Wheel Drive Models
Recreational towing is allowed ONLY if the rear wheels are OFF the ground. This may be accomplished using a tow dolly or vehicle trailer. If using a tow dolly, follow this procedure: 1. Properl ...

Shifting Into NEUTRAL (N)
WARNING! You or others could be injured if you leave the vehicle unattended with the transfer case in the NEUTRAL (N) position without first fully engaging the parking brake. The transfer case ...

See also:

Dinghy towing
Your vehicle is not designed to be dinghy towed (with 4 wheels on the ground) behind a motor home. NOTICE ■To avoid serious damage to your vehicle Do not tow your vehicle with 4 wheels on ...

Registering by phone
1. Select the “BY PHONE” menu. 2. Select the “CONFIRM” menu. Then “TRANSFER” is displayed. 3. Transfer the data from the cell phone. For details about transferring the data, refer t ...

Back–Up Lamp
Removal of the lamp assembly is not required to replace the back-up lamp bulb. To replace one of these lamps: 1. Open the liftgate. See Liftgate on page 2‑9. 2. Remove the interior trim acces ...