Suzuki Grand Vitara: Rear Window Wiper/Washer Switch - Steering Column Controls - Suzuki Grand Vitara Owner's ManualSuzuki Grand Vitara: Rear Window Wiper/Washer Switch

Switch
Rear Window Wiper/Washer Switch

To turn the rear wiper on, twist the rear wiper switch on the end of the lever forward to the “ON” position. If your vehicle is equipped the “INT” position, the rear wiper operates intermittently when you twist the switch forward to the “INT” position. To turn the rear wiper off, twist the switch rearward to the “OFF” position. With the rear wiper in the “OFF” position, twist the switch rearward and hold it there to spray window washer fluid. With the rear wiper in the “ON” position, turn the switch forward and hold it there to spray window washer fluid.

CAUTION: Clear ice or snow from the rear window and rear wiper blade before using the rear wiper. Accumulated ice or snow could prevent the wiper blade from moving, causing damage to the wiper motor.

    Windshield Wiper and Washer Lever
    Windshield Wipers To turn the windshield wipers on, move the lever up and down to one of the four operating positions. In the “INT” position (if equipped), the wipers operate intermittently. ...

    Tilt Steering Lock Lever
    Tilt Steering Lock Lever The release lever is located under the steering column. To adjust the steering wheel height: 1) Pull up the lock lever to unlock the steering column. 2) Adjust the ste ...

    See also:

    Setting the side air vents
    To open/close: turn thumbwheel 3 up or down. Side window defroster vent 1 is never completely shut, even if side air vent 2 is shut. ...

    Electrical Power Outlet
    Your vehicle is equipped with a fused 12 Volt (13 Amp) power outlet. This power outlet is located on the instrument panel, below the climate controls. It has power available when the ignition sw ...

    Replacing fog lamp bulbs (if equipped)
    1. Make sure the fog lamp switch is in the off position. 2. From underneath the vehicle, carefully disconnect the electrical connector from the bulb. 3. Remove the bulb from the lamp assembly by ...