Suzuki Grand Vitara: Overhead Console Box (if equipped) - Other Controls and Equipment - Suzuki Grand Vitara Owner's ManualSuzuki Grand Vitara: Overhead Console Box (if equipped)

Box (if equipped)
Overhead Console Box (if equipped)

To use the overhead console box, push on the front edge (1) and open the lid. To close the lid, push the front edge (1) until it latches. Do not put heavy or sharp items in the box.

overhead console box lid open. It could cause injury if an accident occurs. WARNING: Never drive with the overhead console box lid open. It could cause injury if an accident occurs.

CAUTION: If you park your vehicle outdoors in direct sunlight or in hot weather, the eyeglasses compartment can get very hot since it is close to the roof. So, when parking in such conditions:
• Do not leave eyeglasses in the compartment. The heat may distort plastic lenses or frames.
• Do not place flammable items, such as a lighter, in the compartment. The heat may cause a fire.

NOTE: An aftermarket garage door opener can be installed in the front side overhead console box.

    Cup Holder and Storage Bin (if equipped)
    Cup holders and a storage bin are provided as shown. To access a bin, push the release button. To use the console bin, pull the lever up and open the lid. To use the rear cup holders, open th ...

    Accessory Socket (if equipped)
    12-volt accessory sockets are located both on the center console and on the left side of the luggage compartment. Depending on the specification, there are two sockets on the center console. E ...

    See also:

    Disability modifications
    Occupants with disabilities which may require modification of the vehicle, must contact a Dealer/Authorised Repairer before any modifications are made. ...

    Electronic Roll Mitigation (ERM)
    This system anticipates the potential for wheel lift by monitoring the driver’s steering wheel input and the speed of the vehicle. When ERM determines that the rate of change of the steering w ...

    P Metric
    With the P-Metric system, Section Width is measured in millimeters. To convert millimeters into inches, divide by 25.4. The Aspect Ratio (Section Height divided by Section Width) helps provid ...