Mitsubishi Outlander: Inside rear-view mirror - Starting and driving - Mitsubishi Outlander Owner's ManualMitsubishi Outlander: Inside rear-view mirror

Adjust the rear-view mirror only after making any seat adjustments so you have a clear view to the rear of the vehicle.

WARNING:
● Do not attempt to adjust the rear-view mirror while driving. This can be dangerous. Always adjust the mirror before driving.

Adjust the rear-view mirror to maximize the view through the rear window.

To adjust the vertical mirror position

It is possible to move the mirror up and down to adjust its position.

It is possible to move the mirror up and down to adjust its position.

To reduce the glare

1- Normal. 2- Anti-glare.

1- Normal. 2- Anti-glare.

The lever (A) at the bottom of the mirror can be used to adjust the mirror to reduce the glare from the headlamps of vehicles behind you during night driving.

    Steering wheel height adjustment
    1. Release the tilt lock lever while holding the steering wheel up. 2. Adjust the steering wheel to the desired height. 3. Securely lock the steering wheel by pulling the tilt lock lever fully upw ...

    Outside rear-view mirrors
    To adjust the mirror position The outside rear-view mirrors can be operated when the ignition switch is in the “ON” or “ACC” position. WARNING: ● Do not attempt to adjust the rear- ...

    See also:

    Training phrases
    During the SA mode, the system instructs you to say the following phrases. (The system will prompt you for each phrase.) - phonebook transfer entry - dial 3 0 4 2 9 - delete call back number ...

    Please bear the following in mind
    For safety reasons, Mercedes-Benz recommends that you only use Tires and wheels which have been approved by Mercedes-Benz specifically for your vehicle. These tires have been specially adapted f ...

    Parking brake
    1 Sets the parking brake Fully apply the parking brake while depressing the brake pedal. 2 Releases the parking brake Slightly raise the lever and lower it completely while pressing the button. ...