GMC Terrain: How to Reinstall Engine Air Cleaner/Filter - Engine Air Cleaner/Filter - Vehicle Checks - Vehicle Care - GMC Terrain Owner's ManualGMC Terrain: How to Reinstall Engine Air Cleaner/Filter

1. Install the air cleaner filter into the air cleaner housing. The outer air cleaner filter seal must be fitted properly in the air cleaner housing.
2. Align the air cleaner housing cover tabs to the air cleaner housing.
3. Install the air cleaner housing cover using the four screws.

WARNING

Operating the engine with the air cleaner/filter off can cause you or others to be burned. The air cleaner not only cleans the air; it helps to stop flames if the engine backfires. Use caution when working on the engine and do not drive with the air cleaner/filter off.

Notice: If the air cleaner/filter is off, dirt can easily get into the engine, which could damage it. Always have the air cleaner/filter in place when you are driving.

    How to Inspect the Engine Air Cleaner/Filter
    To inspect the air cleaner/filter, remove the filter from the vehicle and lightly shake the filter to release loose dust and dirt. If the filter remains covered with dirt, a new filter is required ...

    Cooling System
    2.4L L4 Engine A. Engine Cooling Fan (Out of View) B. Engine Coolant Surge Tank and Pressure Cap 3.0L V6 Engine A. Engine Cooling Fans (Out of View) B. Engine Coolant Surge Tank and Pressure ...

    See also:

    Storage compartment
    - Always keep the storage compartment closed while driving to reduce the risk of injury in the event of a sudden stop or an accident. - Do not store spray cans, containers with flammabl ...

    Removing the jack and tools
    1. The jack and tools are located under the carpeted load floor. 2. Pull back the carpet away from the liftgate, and remove the hardboard cover. If your vehicle is equipped with a cargo managemen ...

    When to Add Engine Oil
    2.4L L4 Engine 3.0L V6 Engine If the oil is below the cross-hatched area at the tip of the dipstick, add 1 L (1 qt) of the recommended oil and then recheck the level. See “Selecting the Righ ...