Jeep Liberty: Draining Fluid - Transfer Case - Maintenance Procedures - Maintaining Your Vehicle - Jeep Liberty Owner's ManualJeep Liberty: Draining Fluid

First remove the fill plug (1), then the drain plug (2).

Recommended tightening torque for the drain and fill plugs is 15–25 ft lbs (20–34 N·m).

CAUTION!
Do not over-tighten the plugs. You could damage them and cause a leak.

    Adding Fluid
    Fluid should be added only to fill hole until fluid begins to run out of the hole. ...

    Lubricant Selection
    Use only manufacturer’s recommended fluid. Refer to “Fluids, Lubricants, and Genuine Parts” in “Maintaining Your Vehicle” for further information. ...

    See also:

    On and off
    To switch Collision Warning on or off, press MY CAR on the center console control panel and go to Settings Car settings Driver support systems Collision Warning. If Collision Warni ...

    Child seat positioning
    Crash statistics show that children are safest when properly restrained in a child or infant restraint system that is secured in a rear seating position. Information given within the table i ...

    Coolant temperature low indicator light (if equipped)/Coolant temperature high warning light (if equipped)
    - After turning the ignition switch to the “ON” position, if this indicator light/warning light behaves under any of the following conditions, the electrical system may be malfun ...