Subaru Forester: Cooling or dehumidifying - Air conditioner operation - Manual climate control system (if equipped) - Climate control - Subaru Forester Owner's ManualSubaru Forester: Cooling or dehumidifying

Cooling or dehumidifying
Cooling or dehumidifying

1) ON position

For cooling and dehumidification of the passenger compartment, performing the following steps will allow air to flow through the instrument panel outlets:
1. Set the air inlet selection button to the OFF position.

2. Set the airflow control dial to the “position.” position.

3. Set the air conditioner button to the “ON” position.

4. Set the temperature control dial to the blue side.

5. Set the fan speed control dial at the highest speed.

    Defrosting or defogging
    Defrosting or defogging To direct warm air to the windshield and front door windows: 1. Set the airflow control dial to the “” position. 2. Set the temperature control dial to the red ...

    See also:

    Oil Change Required
    Your vehicle is equipped with an engine oil change indicator system. The “Oil Change Required” message will flash in the EVIC display for approximately 10 seconds after a single chime has so ...

    Adjusting
    1. Press the L button for the left door mirror or the R button for the right door mirror. The light in the button comes on. 2. Adjust the position with the joystick in the center. 3. Press the ...

    Rearview Camera and Monitor
    On EX-L model with navigation system Whenever you shift to reverse (R) with the ignition switch in the ON (II) position, the rearview is shown on the navigation system screen. For the best p ...