Controls. Controls. Compass">

GMC Terrain: Compass - Controls - Instruments and<span lang= Controls - GMC Terrain Owner's Manual" border="0" width="100" align=right style="margin: 0px 3px 0 3px">GMC Terrain: Compass

The vehicle may have a compass display on the Driver Information Center (DIC). The compass receives its heading and other information from the Global Positioning System (GPS) antenna, StabiliTrak, and vehicle speed information.

Avoid covering the GPS antenna for long periods of time with objects that may interfere with the antenna's ability to receive a satellite signal. See Multi-Band Antenna on page 7‑14 for the location of the vehicle's antenna. The compass system is designed to operate for a certain number of miles or degrees of turn before needing a signal from the GPS satellites. When the compass display shows CAL, drive the vehicle for a short distance in an open area where it can receive a GPS signal. The compass system will automatically determine when a GPS signal is restored and provide a heading again. See Compass Messages on page 5‑27 for more information on the messages that may be displayed for the compass.

    Reverse Gear Wipes
    If the rear wiper control is off, the rear wiper will automatically operate continuously when the shift lever is in R (Reverse), and the front windshield wiper is performing low or high speed wipe ...

    Clock
    To set the time: 1. Press the CONFIG button to enter the menu options. Turn the TUNE/MENU knob to scroll through the available setup features. Press the TUNE/MENU knob or press the Time screen bu ...

    See also:

    Lower Anchor and Top Tether Anchor Locations
    Rear Seat (Top Tether Anchor): Seating positions with top tether anchors. (Lower Anchor): Seating positions with two lower anchors. The rear outboard seating positions have exposed metal anch ...

    Steering wheel keypad
    The keypad varies according to the vehicle's equipment 1 Turn the thumb wheel to go up/down among menu selections. Press the thumb wheel to make a selection or store a function in the system' ...

    Around viewTM monitor (if equipped)
    The CAMERA button is located on the center console. When you push the CAMERA button or shift the selector lever into the “R” (Reverse) position while the ignition switch is in the ON posi ...