Controls. Warning Lights, Gauges, and Indicators. Brake System Warning Light">

GMC Terrain: Brake System Warning<span lang= Light - Warning Lights, Gauges, and Indicators - Instruments and Controls - GMC Terrain Owner's Manual" border="0" width="100" align=right style="margin: 0px 3px 0 3px">GMC Terrain: Brake System Warning Light

The vehicle brake system consists of two hydraulic circuits. If one circuit is not working, the remaining circuit can still work to stop the vehicle. For normal braking performance, both circuits need to be working

The brake indicator light should come on briefly as the engine is started. If

The brake indicator light should come on briefly as the engine is started. If it does not come on have the vehicle serviced by your dealer. When the ignition is on, the brake system warning light comes on when the parking brake is set. The light stays on if the parking brake does not fully release. If it stays on after the parking brake is fully released, there is a brake problem. Have the brake system inspected immediately.

WARNING

The brake system might not be working properly if the brake system warning light is on. Driving with the brake system warning light on can lead to a crash. If the light is still on after the vehicle has been pulled off the road and carefully stopped, have the vehicle towed for service.

If the light comes on while driving, a chime sounds. Pull off the road and stop. The pedal might be harder to push or go closer to the floor. It might also take longer to stop. If the light is still on, have the vehicle towed for service. See Towing the Vehicle on page 10‑79.

    Emissions Inspection and Maintenance Programs
    Some local governments may have programs to inspect the on-vehicle emission control equipment. For the inspection, the emission system test equipment is connected to the vehicle’s Data Link Conn ...

    Antilock Brake System (ABS) Warning Light
    For vehicles with the Antilock Brake System (ABS), this light comes on briefly when the engine is started. If the light does not come on, have it fixed so it will be ready to warn if there is a ...

    See also:

    Extra high beam
    1. Remove the headlight housing from the vehicle (see page 322). 2. Remove the cover over the bulbs (see page 323). 3. Disconnect the wiring connector from the bulb holder. 4. Remove the bu ...

    Sun Visor
    To use the sun visor, pull it down. When using the sun visor for the side window, remove the support rod from the clip, and swing it out. Make sure you put the sun visor back in place when ...

    Dual view selection
    When the ignition is switched on or the audio unit is turned on after being turned off, single view mode will be the default view. To select dual view, press the dual view hard key on the fascia s ...