Ford Escape: Using the right bulbs - Bulb Replacement - Lights - Ford Escape Owner's ManualFord Escape: Using the right bulbs

Replacement bulbs are specified in the chart below. Headlamp bulbs must be marked with an authorized “D.O.T.” for North America and an “E” for Europe to ensure lamp performance, light brightness and pattern and safe visibility. The correct bulbs will not damage the lamp assembly or void the lamp assembly warranty and will provide quality bulb burn time.

Replacing headlamp bulbs

    Lamp assembly condensation
    Exterior lamps are vented to accommodate normal changes in pressure. Condensation can be a natural by-product of this design. When moist air enters the lamp assembly through the vents, there is a ...

    Replacing headlamp bulbs
    1. Make sure the headlamp control is in the off position. 2. Open the hood. 3. Reach over the front bolster. 4. Remove the bulb by turning it counterclockwise and then pulling it straight out. ...

    See also:

    How to Check
    Use a good quality pocket-type gauge to check tire pressure. Proper tire inflation cannot be determined by looking at the tire. Check the tire inflation pressure when the tires are cold, meaning t ...

    Safety Locks
    The rear door safety locks switch is on the instrument panel. Rear door safety locks prevent passengers from opening the rear doors from inside the vehicle. Press to activate the safety locks. ...

    Cruise Control
    Cruise control allows you to maintain a set speed above 25 mph (40 km/h) without keeping your foot on the accelerator pedal. It should be used for cruising on straight, open highways. It is ...