Ford Escape: Sound Adjustments - AM/FM single CD/MP3 satellite compatible sound system - Audio systems - Entertainment Systems - Ford Escape Owner's ManualFord Escape: Sound Adjustments

Press SOUND repeatedly to cycle through the following features:

• BASS: Press or turn the tune knob to SEEK/TRACK adjust or turn the tune knob to adjust the level of bass.

• TREBLE: Press or turn the tune knob to SEEK/TRACK adjust the level of treble. or turn the tune knob to adjust the level of treble.

• BALANCE: Press or turn the tune knob to SEEK/TRACK adjust the audio between the left (L) and right (R) speakers. or turn the tune knob to adjust the audio between the left (L) and right (R) speakers.

• FADE: Press or turn the tune knob to SEEK/TRACK adjust or turn the tune knob to adjust the audio between the back (B) and front (F) speakers.

• SPEED COMPENSATED VOLUME (if equipped): Allows the radio volume to automatically adjust with vehicle speed to compensate for road and wind noise. Use SEEK/TRACK  to select from 1 SEEK/TRACK (lowest) to 7 (highest) or to turn the feature off (SPEED OFF). The to select from 1 (lowest) to 7 (highest) or to turn the feature off (SPEED OFF). The default setting is off.

• ALL SEATS (Occupancy mode, if equipped): Press SOUND repeatedly to reach the Occupancy mode setting. Press to select to optimize sound SEEK/TRACK for ALL SEATS, to select to optimize sound for ALL SEATS, DRIVERS SEAT or REAR SEATS.

    Satellite Radio (if equipped)
    Satellite radio is available only with a valid SIRIUS radio subscription. Check with your authorized dealer for availability. SIRIUS: Press to access satellite radio mode, if equipped. Press repeat ...

    Extra Features
    AUX: Press repeatedly to cycle through LINE IN (auxiliary audio mode), and SYNC (if equipped). For location and further information on auxiliary audio mode, refer to Auxiliary input jack later in ...

    See also:

    Cargo and dome lamp
    Rear cargo lamp equipped with an ON/OFF/DOOR control will light when: • the doors are closed and the control is in the ON position. • the control is in the DOOR position and any door is op ...

    Seat belt inspection
    ● Check the belts for cuts, worn or frayed webbing and for cracked or deformed metallic parts. Replace the belt assembly if defective. ● A dirty belt should be cleaned with neutral d ...

    Opening and closing
    Overhead control panel To open To open To close Turn the SmartKey to position 1 or 2 in the ignition lock. Press or pull the switch in the corresponding direction. If you press ...