Ford Escape: Replacing high-mount brake lamp bulbs
1. Remove the two screws and move the lamp assembly away from the liftgate.
2. Remove the bulb holder from the lamp assembly by pressing the snaps.
3. Pull the bulb straight out of the socket and push in the new bulb.
Install the new bulbs in reverse order.
Replacing tail/stop/turn/backup lamp bulbs
The tail/stop/turn/sidemarker/backup lamp bulbs are located in the same
portion of the tail lamp assembly, one just below the other. Follow the
same steps to replace either bulb:
1. Make sure the ...
Replacing license plate lamp bulbs
1. Make sure the headlamp switch is
in the off position.
2. Press the lever and carefully pry
the license plate lamp assembly
(located above the license plate)
from the liftgate.
3. Rotate the b ...
See also:
Cruise Control
With cruise control, the vehicle can maintain a speed of about 40 km/h (25 mph)
or more without keeping your foot on the accelerator. Cruise control does not work
at speeds below 40 km/h (25 mph). ...
California perchlorate advisory
Some vehicle parts, such as lithium batteries,
may contain perchlorate material.
The following advisory is provided: “Perchlorate
Material - special handling may
apply, See www.dtsc.ca.gov/
...
Transmission positions
Park position
Do not shift the transmission into position P() unless the vehicle
is stationary. The parking lock should not be used as a brake when parking. In addition
to engaging the parking lo ...