Ford Escape: Cargo shade (if equipped)
If your vehicle has a cargo shade, you can use it to cover items in the cargo area of your vehicle.
To install the shade:
• Insert the ends of the cargo shade into the mounting features located behind the rear seat on the rear trim panels.
To operate the shade:
1. Grasp the rear edge of the cargo
shade and pull rearward.
2. Secure both ends of the support
rod into the retention slots located
on the rear quarter trim panels.
WARNING: Ensure that the posts are properly latched in
mounting features. The cover may cause injury in a sudden stop
or accident if it is not securely installed.
WARNING: Do not place any objects on the cargo area shade.
They may obstruct your vision or strike occupants of vehicle in the case of a sudden stop or collision.
Cargo management system (if equipped)
The cargo management system consists of two storage compartments
located in the floor of the rear cargo area.
The larger, rearward, compartment is
for customer storage. To open, lift
the lid with ...
See also:
Reporting safety defects
For USA
If you believe that your vehicle has a defect
which could cause a crash or could cause
injury or death, you should immediately
inform the National Highway Traffic Safety
Administratio ...
Pairing and connecting from your mobile phone
Note: The process of pairing and connecting
your phone with the vehicle using the mobile
phone, will vary depending on the type of
mobile phone used.
1. Switch the ignition on and ensure that the
...
Lap/Shoulder Belt Untwisting Procedure
Use the following procedure to untwist a twisted lap/
shoulder belt.
1. Position the latch plate as close as possible to the
anchor point.
2. At about 6 to 12 in (15 to 30 cm) above the latch pl ...
