Jeep Liberty: Using HomeLink
To operate, press and release the programmed HomeLink button. Activation will now occur for the programmed device (i.e., garage door opener, gate operator, security system, entry door lock, home/office lighting, etc.,). The hand-held transmitter of the device may also be used at any time.
Canadian/Gate Operator Programming
For programming transmitters in Canada/United States that require the transmitter signals to “time-out” after several seconds of transmission. Canadian radio frequency laws require transmitte ...Security
It is advised to erase all channels before you sell or turn in your vehicle. To do this, press and hold the two outside buttons for 20 seconds until the red indicator flashes. Note that all cha ...See also:
License Plate Lamp
To replace one of these bulbs:
1. Open the liftgate partway. See Liftgate on page 2‑9.
Passenger Side Shown, Driver Side Similar
2. Push the left end of the lamp assembly toward the right.
...
Front Fog Light Switch (if equipped)
Front Fog Light
Switch (if equipped)
The front fog light comes on when the fog light switch is pushed in with:
• the lighting switch turned to the third position and the beams set to the low
...
Where to place a child restraint system
The following are SUBARU’s recommendations
on where to place a child restraint
system in your vehicle.
A: Front passenger’s seat
You should not install a child restraint
system (includin ...