Jeep Liberty: Garage Door Opener — If Equipped
HomeLink replaces up to three hand-held transmitters that operate devices such as garage door openers, motorized gates, lighting or home security systems. The HomeLink unit is powered by your vehicles 12 Volt battery.
The HomeLink buttons, located on either the overhead console, headliner or sunvisor, designate the three different HomeLink channels. The HomeLink indicator is located above the center button.
HomeLink Buttons/Overhead Consoles
HomeLink Buttons/Sunvisor/Headliner
NOTE: HomeLink is disabled when the Vehicle Security Alarm is active.
- Before You Begin Programming HomeLink
- Programming A Rolling Code
- Programming A Non-Rolling Code
- Canadian/Gate Operator Programming
- Using HomeLink
- Security
- Troubleshooting Tips
- General Information
Parksense System Usage Precautions
NOTE: • Ensure that the rear bumper is free of snow, ice, mud, dirt and debris to keep the ParkSense system operating properly. • Jackhammers, large trucks, and other vibrations could aff ...Before You Begin Programming HomeLink
Be sure that your vehicle is parked outside of the garage before you begin programming. For more efficient programming and accurate transmission of the radio-frequency signal it is recommended th ...See also:
Multi-point inspection
In order to keep your vehicle running right, it is important to have the
systems on your vehicle checked regularly. This can help identify
potential issues and prevent major problems. Ford Motor Com ...
Cleaning the seat belts
Use clean, lukewarm water and soap solution.
Do not clean the seat belts using chemical cleaning agents. Do not dry the
seat belts by warming them above 176 ‡ (80 †) or placing them in ...
Introduction
The following pages provide
instructions on how to properly
protect the driver, adult passengers,
and teenage children who are large
enough and mature enough to drive
or ride in the front.
...