GMC Terrain: License Plate Lamp
To replace one of these bulbs:
1. Open the liftgate partway. See Liftgate on page 2‑9.
Passenger Side Shown, Driver Side Similar
2. Push the left end of the lamp assembly toward the right.
3. Pull the lamp assembly down to remove it from the liftgate.
A. Bulb Socket
B. Bulb
C. Lamp Assembly
4. Turn the bulb socket (A) counterclockwise to remove it from the lamp assembly (C).
5. Pull the bulb (B) straight out of the bulb socket.
6. Push the replacement bulb straight into the bulb socket and turn the bulb socket clockwise to install into lamp assembly.
7. Turn the lamp assembly into the liftgate engaging the clip side first.
8. Push on the lamp side opposite the clip until the lamp assembly snaps into place.
Back–Up Lamp
Removal of the lamp assembly is not required to replace the back-up lamp bulb. To replace one of these lamps: 1. Open the liftgate. See Liftgate on page 2‑9. 2. Remove the interior trim acces ...Replacement Bulbs
For replacement bulbs not listed here, contact your dealer. ...See also:
HD Radio indicators
Each indicator illuminates under the following
conditions.
- The indicator illuminates while
the
digital broadcast is received during the HD
Radio ON mode.
- The “TAG” indicator illumin ...
Removing the Flat Tire and Installing the Spare Tire
1. Do a safety check before proceeding. See If a Tire Goes Flat on page 10‑65
for more information.
2. For vehicles with a wheel cover or center cap, pull the cover or center cap
away from ...
General information
Do not exceed the legally prescribed maximum speed for vehicle/trailer
combinations in the relevant country. This lowers the risk of an accident.
Only install an approved trailer coupling on y ...