Jeep Liberty: To Enter Remote Start Mode - How To Use Remote Start - Remote Starting System — If Equipped - Things To Know Before Starting Your Vehicle - Jeep Liberty Owner's ManualJeep Liberty: To Enter Remote Start Mode

Press and release the REMOTE START button

Press and release the REMOTE START button on the RKE transmitter twice within five seconds.

The parking lights will flash and the horn will chirp twice (if programmed). Then, the engine will start and the vehicle will remain in the Remote Start mode for a 15-minute cycle.

NOTE:
• If your power door locks were unlocked, Remote Start will automatically lock the doors.

• If an engine fault is present or fuel level is low, the vehicle will start and then shut down in 10 seconds.

• For security, power window operation and sunroof or Sky Slider operation (if equipped) is disabled when the vehicle is in the Remote Start mode.

• The engine can be started two consecutive times (two 15-minute cycles) with the RKE transmitter. However, the ignition switch must be cycled to the ON/RUN position before you can repeat the start sequence for a third cycle.

    Remote Start Abort Message On Electronic Vehicle Information Center (EVIC) — If Equipped
    The following messages will display in the EVIC if the vehicle fails to remote start or exits remote start prematurely: • Remote Start Aborted — Door Ajar • Remote Start Aborted — Hood A ...

    To Exit Remote Start Mode Without Driving The Vehicle
    Press and release the REMOTE START button one time or allow the engine to run for the entire 15-minute cycle. NOTE: To avoid unintentional shut downs, the system will disable the one-time press o ...

    See also:

    Seek tuning (SEEK)
    Type A and B audio: Type C audio: Type D audio: If you press the “” or “” button briefly, the radio will automatically search for a receivable station and stop at the first one ...

    Sensor blockage
    If one of the sensors is completely obscured the BSM system is automatically disabled, the warning indicator dot is displayed in the exterior mirror and the message BSM sensor blocked appears in t ...

    Programming
    Programming With the engine switched off; 1. Ensure that the ignition system is on. 2. Hold the signal emitting end of the original garage door opener hand-held transmitter 50 to 150 mm (2 to 6 ...