Jeep Liberty: Using HomeLink - Garage Door Opener — If Equipped - Understanding The Features Of Your Vehicle - Jeep Liberty Owner's ManualJeep Liberty: Using HomeLink

To operate, press and release the programmed HomeLink button. Activation will now occur for the programmed device (i.e., garage door opener, gate operator, security system, entry door lock, home/office lighting, etc.,). The hand-held transmitter of the device may also be used at any time.

    Canadian/Gate Operator Programming
    For programming transmitters in Canada/United States that require the transmitter signals to “time-out” after several seconds of transmission. Canadian radio frequency laws require transmitte ...

    Security
    It is advised to erase all channels before you sell or turn in your vehicle. To do this, press and hold the two outside buttons for 20 seconds until the red indicator flashes. Note that all cha ...

    See also:

    Rear Window Defogger
    REAR (Rear Defogger): Press to turn the rear window defogger on or off. The rear window defogger turns off after about 10 minutes. It can also be turned off by turning the ignition to ACC/ACCESSO ...

    Re-installing the wheel
    1. Clean the contact surfaces on the wheel and hub. 2. Lift the wheel and place it on the hub. Tighten the lug nuts 3. Install the wheel nuts and tighten handtight. Using the lug wrench, tight ...

    Ashtray (if equipped)
    - Do not use ashtrays as waste receptacles or leave a lighted cigarette in an ashtray. This could cause a fire. - Always extinguish matches and cigarettes before putting them into the a ...