Jeep Liberty: Security
It is advised to erase all channels before you sell or turn in your vehicle.
To do this, press and hold the two outside buttons for 20 seconds until the red indicator flashes. Note that all channels will be erased. Individual channels cannot be erased.
The HomeLink Universal Transceiver is disabled when the Vehicle Security Alarm is active.
Using HomeLink
To operate, press and release the programmed
HomeLink button. Activation will now occur for the
programmed device (i.e., garage door opener, gate operator,
security system, entry door lock, home ...
Troubleshooting Tips
If you are having trouble programming HomeLink , here
are some of the most common solutions:
• Replace the battery in the original hand-held transmitter.
• Press the LEARN button on the Garage ...
See also:
Cleaning the exterior lighting
Clean the plastic lenses of the exterior lights with a wet sponge and
a mild cleaning agent, e.g. Mercedes-Benz car shampoo or cleaning cloths.
Only use cleaning agents or cleaning cloths ...
Using tmc
Dynamic route guidance will calculate an
alternative route to avoid a traffic event when
the system receives an event warning.The
system calculates a new route for all sections.
However, if any wa ...
Slippery road surfaces
WARNING
The outside temperature indicator is not designed to serve as an ice-warning
device and is therefore unsuitable for that purpose.
Indicated temperatures just above the freezing point ...