Jeep Liberty: Reset
• press the button.
• After the “Ready” prompt, and the following beep, say “Setup”, then “Reset”.
This will delete all phone pairing, phone book entries, and other settings in all language modes. The System will prompt you before resetting to factory settings.
Voice Training
For users experiencing difficulty with the system recognizing
their voice commands or numbers, the Uconnect™
Phone Voice Training feature may be used. To enter this
training mode, follow one o ...
Voice Command
• For best performance, adjust the rearview mirror to
provide at least 1⁄2 in (1 cm) gap between the overhead
console (if equipped) and the mirror.
• Always wait for the beep before spe ...
See also:
Stopping the engine
The ignition switch should be turned off
only when the vehicle is stopped and the
engine is idling.
Do not stop the engine when the
vehicle is moving. This will cause
loss of power to the ...
Current speed in km/h (U.S. models only)
This function provides the driver with an instantaneous
conversion of the car's current speed
from mph to km/h. ...
Speed sensitive wipers
If vehicle speed drops below 6km/h (3.7mph)
with the wipers operating in positions (2) or
(3), the wipers will switch to the next lowest
speed. When vehicle speed increases to over
6km/h (3.7mph), ...