Jeep Liberty: Voice Command - Things You Should Know About Your Uconnect™ Phone - Uconnect™ Phone — If Equipped - Understanding The Features Of Your Vehicle - Jeep Liberty Owner's ManualJeep Liberty: Voice Command

• For best performance, adjust the rearview mirror to provide at least 1⁄2 in (1 cm) gap between the overhead console (if equipped) and the mirror.

• Always wait for the beep before speaking.

• Speak normally, without pausing, just as you would speak to a person sitting a few feet/meters away from you.

• Make sure that no one other than you is speaking during a Voice Command period.

• Performance is maximized under:
• low-to-medium blower setting,
• low-to-medium vehicle speed,
• low road noise,
• smooth road surface,
• fully closed windows,
• dry weather condition.

• Even though the system is designed for users speaking in North American English, French, and Spanish accents, the system may not always work for some.

• When navigating through an automated system such as voice mail, or when sending a page, at the end of speaking the digit string, make sure to say “Send”.

• Storing names in the phonebook when the vehicle is not in motion is recommended.

• It is not recommended to store similar sounding names in the Uconnect™ Phonebook.

• Phonebook (Downloaded and Uconnect™ Phone Local) name recognition rate is optimized when the entries are not similar.

• Numbers must be spoken in single digits. “800” must be spoken “eight-zero-zero” not “eight hundred”.

• You can say “O” (letter “O”) for “0” (zero).

• Even though international dialing for most number combinations is supported, some shortcut dialing number combinations may not be supported.

• In a convertible vehicle, system performance may be compromised with the convertible top down.

    Reset
    • press the button. • After the “Ready” prompt, and the following beep, say “Setup”, then “Reset”. This will delete all phone pairing, phone book entries, and other settings in ...

    Far End Audio Performance
    • Audio quality is maximized under: • low-to-medium blower setting, • low-to-medium vehicle speed, • low road noise, • smooth road surface, • fully closed windows, • dry weat ...

    See also:

    To Arm The System
    1. Remove the key from the ignition switch and exit the vehicle. 2. Lock the doors and liftgate by pressing the power door LOCK switch or the LOCK button on the Remote Keyless Entry (RKE) trans ...

    High/low beam headlights
    Headlight switch and lever 1 High beam flash 2 Toggle between high and low beams ...

    How To Engage The Automatic Locking Mode
    1. Buckle the combination lap and shoulder belt. 2. Grasp the shoulder portion and pull downward until the entire belt is extracted. 3. Allow the belt to retract. As the belt retracts, you will ...