Jeep Liberty: Garage Door Opener — If Equipped
HomeLink replaces up to three hand-held transmitters that operate devices such as garage door openers, motorized gates, lighting or home security systems. The HomeLink unit is powered by your vehicles 12 Volt battery.
The HomeLink buttons, located on either the overhead console, headliner or sunvisor, designate the three different HomeLink channels. The HomeLink indicator is located above the center button.
HomeLink Buttons/Overhead Consoles
HomeLink Buttons/Sunvisor/Headliner
NOTE: HomeLink is disabled when the Vehicle Security Alarm is active.
- Before You Begin Programming HomeLink
- Programming A Rolling Code
- Programming A Non-Rolling Code
- Canadian/Gate Operator Programming
- Using HomeLink
- Security
- Troubleshooting Tips
- General Information
Parksense System Usage Precautions
NOTE:
• Ensure that the rear bumper is free of snow, ice, mud,
dirt and debris to keep the ParkSense system operating
properly.
• Jackhammers, large trucks, and other vibrations could
aff ...
Before You Begin Programming HomeLink
Be sure that your vehicle is parked outside of the garage
before you begin programming.
For more efficient programming and accurate transmission
of the radio-frequency signal it is recommended th ...
See also:
Other Information
The Bluetooth® word mark and logos are owned by the Bluetooth® SIG, Inc. and
any use of such marks by General Motors is under license. Other trademarks and trade
names are those of their respect ...
Displayed area
Vehicles without spare tire
The area covered by the camera is limited.
Objects that are close to either
corner of the bumper or under the
bumper cannot be seen on the screen.
The area displayed ...
Wireless remote control
The wireless remote control can be used to lock and unlock the vehicle
from outside the vehicle.
Vehicles without smart key system
1 Locks all doors
2 Pushing and holding: Sounds alarm
3 Unlock ...
