Volvo XC60: Setting a speed
Once ACC has been put in standby mode, use the or buttons to store (set) the vehicle's current speed. This puts the system in active mode. The set speed, for example 55 mph, is shown in the display.
When the symbol on the left side of the display changes to , the radar sensor has detected another vehicle ahead. The distance to a vehicle ahead is only regulated when this symbol () is illuminated.
Putting ACC in standby mode
Before ACC can be used to regulate speed and/or the distance to a vehicle ahead, it must first be put in standby mode. To do so: Press . The symbol appears in the display and parentheses ( ...Changing the set speed
After a speed has been set, it can be increased or decreased by using the or buttons. Each time one of these buttons is pressed, the vehicle's speed changes by 5 mph (approximately 8 km/h). ...See also:
Power Windows
Turn the ignition switch to the ON
(II) position to raise or lower any
window. To open the window, push
the switch down and hold it. Release
the switch when you want to stop the
window. ...
Indicators for maintenance
1. Service due indicator
This indicator appears when the customer set
distance comes for service due, for example, for
engine oil and oil filter. You can set or reset the
distance for service ...
Before starting the engine
Before you start the engine, you should always:
1. Look around the vehicle to be sure there are
no flat tires, puddles of oil, water or other
indications of possible trouble.
2. After entering ...