Volvo XC60: Changing the set speed
After a speed has been set, it can be increased or decreased by using the or buttons.
Each time one of these buttons is pressed, the vehicle's speed changes by 5 mph (approximately 8 km/h).
When the system is in active mode, the button has the same function as , but results in a smaller increase in speed.
NOTE
• If one of the Adaptive Cruise Control
buttons is pressed for more than
approximately one minute, ACC will be
deactivated. The engine must then be
switched off and restarted to reset ACC.
• In some situations Adaptive Cruise
Control cannot be put in active mode.
Cruise control Unavailable is shown
in the display, see page 162.
Setting a speed
Once ACC has been put in standby mode, use the or buttons to store (set) the vehicle's current speed. This puts the system in active mode. The set speed, for example 55 mph, is shown in th ...Setting a time interval
The set time interval to vehicles ahead can be increased by pressing and decreased by pressing . The current time interval is shown briefly in the display following adjustment. Different ...See also:
How to Reinstall Engine Air Cleaner/Filter
1. Install the air cleaner filter into the air cleaner housing. The outer air
cleaner filter seal must be fitted properly in the air cleaner housing.
2. Align the air cleaner housing cover tabs to ...
Adjusting the Sound
Press the sound (
) button to
select an appropriate setting: bass,
treble, fader, balance, subwoofer (if
equipped), and SVC (speed-sensitive
volume compensation). Turn the
VOL/SELECT knob ...
Programming
Programming
With the engine switched off;
1. Ensure that the ignition system is on.
2. Hold the signal emitting end of the original
garage door opener hand-held transmitter
50 to 150 mm (2 to 6 ...