Volvo XC60: Turn signals
1. Remove the headlight housing from the vehicle (see page 322).
2. Remove the bulb holder by turning it counterclockwise and pulling it out of the headlight housing.
3. Pull out the holder to access the bulb.
4. Remove the burned out bulb by pressing it in slightly and turning it counterclockwise.
5. Press the new bulb into the holder and turn it clockwise.
6. Reinsert the bulb holder into the headlight housing and turn it clockwise.
7. Reinstall the headlight housing.
Extra high beam
1. Remove the headlight housing from the
vehicle (see page 322).
2. Remove the cover over the bulbs (see
page 323).
3. Disconnect the wiring connector from the
bulb holder.
4. Remove the bu ...
Side marker lights
NOTE
Before starting to replace a bulb, see
page 322.
1. Remove the headlight housing from the
vehicle (see page 322).
2. Remove the bulb holder by turning it counterclockwise
and pulling i ...
See also:
Dual view selection
When the ignition is switched on or the audio
unit is turned on after being turned off, single
view mode will be the default view.
To select dual view, press the dual view hard
key on the fascia s ...
Compass and trip computer
The Compass/Trip Computer features a driverinteractive
display (displays information on outside temperature,
compass direction, and trip information). It is
located on the lower left part of the ...
Turn Signals
Move the multifunction lever up or down and the arrows
on each side of the instrument cluster flash to show
proper operation of the front and rear turn signal lights.
Turn Signal Control
NOTE: ...
