Subaru Forester: Meter needles/gauge illumination setting (models with type A combination meter)
When the setting is activated or deactivated, the meter needles and gauge illuminate and turn off as follows.
Activated:
When the driver’s door is opened while the ignition switch is in the “LOCK” position, the needles and gauge illuminate and turn off after approximately 20 seconds.
The illumination gradually turns off after the ignition switch is turned from the “ON” position to the “LOCK” position.
Deactivated:
The needles and gauge do not illuminate when the driver’s door is opened while the ignition switch is in the “LOCK” position.
The illumination turns off immediately after the ignition switch is turned from the “ON” position to the “LOCK” position.
NOTE
- Even during the illumination after
the driver’s door is opened, if the
ignition switch is turned to the “ON”
position, the combination meter will
illuminate as usual.
- If the doors are locked by the remote keyless entry system during the illumination after the driver’s door is opened, the illumination will be turned off.
- Even while the illumination gradually turns off after the ignition switch is turned to the “LOCK” position, if the ignition switch is turned to the “ON” position, the combination meter illuminates as usual.
To change the setting:
1. Turn the ignition switch to the “LOCK” or “Acc” position.
2. Press the trip knob to show or on the trip meter display. The display can be switched as shown in the following illustration by pressing the trip knob.
*: or , and or cannot be displayed when the ignition switch is in the “ON” position.
3. To change the current setting, press the trip knob for at least 2 seconds.
: Activated
: Deactivated
NOTE
The initial illumination setting of the
meter needles/gauge of your vehicle
has been set for activation
at the
time of shipment from the factory.
Canceling the function for meter/gauge needle movement upon turning on the ignition switch
Type A Type B It is possible to activate or deactivate the movement of the meter needles and gauge needles that takes place when the ignition switch is turned to the “ON” position. ...Speedometer
The speedometer shows the vehicle speed. ...See also:
Programming HomeLink®
To program your HomeLink® Transceiver to
operate a garage door, gate, or entry door
opener, home or office lighting, you need to be
at the same location as the device. Note:
Garage door opene ...
Key number plate
The key number is stamped on the key
number plate attached to the key set.
Write down the key number and keep it in
another safe place, not in the vehicle. This
number is needed to make a repla ...
Headlight flasher
Headlight flasher
To flash the headlights, pull the lever
toward you and then release it. The high
beam will remain on for as long as you
hold the lever. The headlight flasher works
even ...