Subaru Forester: Canceling the function for meter/gauge needle movement upon turning on the ignition switch
Type A
Type B
It is possible to activate or deactivate the movement of the meter needles and gauge needles that takes place when the ignition switch is turned to the “ON” position.
1. Turn the ignition switch to the “LOCK” or “Acc” position.
2. Press the trip knob to show or on the odometer/trip meter display.
The display can be switched as shown in the following illustration by pressing the trip knob.
Type A:
*: or , and or cannot be displayed when the ignition switch in the “ON” position.
Type B:
*: or cannot be displayed when the ignition switch is in the “ON” position.
3. To change the current setting, press the trip knob for at least 2 seconds.
: Activated
: Deactivated
NOTE
- Your vehicle’s initial movement
setting of the meter/gauge needles
has been set for activation
at the time of shipment from the
factory.
- It is not possible to cancel the initial movement setting of the meter/gauge needles when the ignition switch is in the “ON” position. Cancel the setting when the ignition switch is in the “LOCK” or “Acc” position.
Combination meter illumination
When the ignition switch is turned to the “ON” position, the various parts of the combination meter are illuminated in the following sequence: 1. Warning lights, indicator lights, meter ...Meter needles/gauge illumination setting (models with type A combination meter)
When the setting is activated or deactivated, the meter needles and gauge illuminate and turn off as follows. Activated: When the driver’s door is opened while the ignition switch is in the ...See also:
Voice Control System
You can select the AUX mode by
using the navigation system voice
control buttons, but cannot operate
the play mode functions.
The specifications for compatible
MP3 files are:
Sampling freque ...
Towing
If towing is necessary, it is best done by
your SUBARU dealer or a commercial
towing service. Observe the following
procedures for safety.
Never tow AWD models (both AT and
MT) with t ...
Smart key check
If the ignition is on or the engine is running and
there is no Smart Key inside the vehicle when
the last door is closed, the message Smart Key
Not Found Refer to Handbook will be displayed
in the ...