Jeep Liberty: Garage Door Opener — If Equipped
HomeLink replaces up to three hand-held transmitters that operate devices such as garage door openers, motorized gates, lighting or home security systems. The HomeLink unit is powered by your vehicles 12 Volt battery.
The HomeLink buttons, located on either the overhead console, headliner or sunvisor, designate the three different HomeLink channels. The HomeLink indicator is located above the center button.
HomeLink Buttons/Overhead Consoles
HomeLink Buttons/Sunvisor/Headliner
NOTE: HomeLink is disabled when the Vehicle Security Alarm is active.
- Before You Begin Programming HomeLink
- Programming A Rolling Code
- Programming A Non-Rolling Code
- Canadian/Gate Operator Programming
- Using HomeLink
- Security
- Troubleshooting Tips
- General Information
Parksense System Usage Precautions
NOTE:
• Ensure that the rear bumper is free of snow, ice, mud,
dirt and debris to keep the ParkSense system operating
properly.
• Jackhammers, large trucks, and other vibrations could
aff ...
Before You Begin Programming HomeLink
Be sure that your vehicle is parked outside of the garage
before you begin programming.
For more efficient programming and accurate transmission
of the radio-frequency signal it is recommended th ...
See also:
Push starting
Do not attempt to start the engine by pushing.
Continuously Variable Transmission
(CVT) models cannot be push-started
or tow-started. Attempting to do so may
cause transmission damage. ...
Fuel pump shut off system
To minimize the risk of fuel leakage when the engine stalls or an airbag
inflates upon collision, the fuel pump shut off system stops supplying
fuel to the engine.
Follow the procedure below to res ...
Cargo compartment enlargement
Important safety notes
WARNING
Always lock the seat backrest in its upright position when the rear seat bench
is occupied, or the extended cargo volume is not in use.
Check for secure lockin ...
