Volvo XC60: Seat belt maintenance - General information - Seat belts - Safety - Volvo XC60 Owner's ManualVolvo XC60: Seat belt maintenance

Check periodically that the seat belts are in good condition. Use water and a mild detergent for cleaning. Check seat belt mechanism function as follows: attach the seat belt and pull rapidly on the strap.

WARNING
Never use a seat belt for more than one occupant. Never wear the shoulder portion of the belt under the arm, behind the back or otherwise out of position. Such use could cause injury in the event of an accident. As seat belts lose much of their strength when exposed to violent stretching, they should be replaced after any collision, even if they appear to be undamaged.

WARNING
• Never repair the belt yourself; have this work done by a trained and qualified Volvo service technician only.
• Any device used to induce slack into the shoulder belt portion of the three-point belt system will have a detrimental effect on the amount of protection available to you in the event of a collision.
• The seat back should not be tilted too far back. The shoulder belt must be taut in order to function properly.
• Do not use child safety seats or child booster cushions/backrests in the front passenger's seat. We also recommend that children who have outgrown these devices sit in the rear seat with the seat belt properly fastened.

    Unbuckling the seat belt
    To remove the seat belt, press the red section on the seat belt receptacle. Before exiting the vehicle, check that the seat belt retracts fully after being unbuckled. If necessary, guide the b ...

    Seat belt reminder
    Seat belt reminder light in ceiling console The seat belt reminder consists of an audible signal, an indicator light near the rearview mirror and a symbol in the instrument panel that alert a ...

    See also:

    Reporting safety defects in the U.S.
    If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHTS ...

    Fog Lights — If Equipped
    To activate the front fog lights, turn on the parking lights or the low beam headlights and pull out on the end of the multifunction lever. Front Fog Light Control NOTE: The front fog lights ...

    Switching on the ignition
    To turn on the ignition without starting the engine: - Do not depress the brake/clutch pedal, - Press the START/STOP button and hold until the warning lamps illuminate, then release the button. ...