Range Rover Evoque: Switching on the ignition

To turn on the ignition without starting the engine:
- Do not depress the brake/clutch pedal, - Press the START/STOP button and hold until the warning lamps illuminate, then release the button.

applied when If the brake/clutch pedal is applied when the start/stop button is pressed, the engine will start.

READ NEXT:

 Engine starting

Never start the engine, or leave it running, when the vehicle is in an enclosed space. Exhaust gasses are poisonous and can cause unconsciousness and death if inhaled. If the engine fails to

 Engine starting: automatic transmission

1. A valid Smart Key must be inside the vehicle. 2. Make sure the gear selector is in P or N. 3. Firmly depress the brake pedal. 4. Press and release the start button. The engine will crank autom

 Engine starting: manual transmission

Note: Do not press the accelerator pedal when starting the engine. 1. A valid Smart Key must be inside the vehicle. 2. Fully depress the clutch pedal. 3. Press and release the start button. For

SEE MORE:

 Transfer Case Seal RH GTDi 2.0L Petrol

Special Tool(s) 100-012 Slide Hammer 205-872 Installer, Transfer Case Seal 308-615 Remover, Seals 308-617 Depth Drill, Seal Remover Removal NOTES: Removal steps in this procedure may contain installation details. Some variation in the illustrations may occur, but the essential information is alway

 Topping up the washer fluid

The washer reservoir supplies the front and rear screen washer jets and headlamp washer jets. Check and top-up the reservoir level at least every week. Always top-up with screen washer fluid to prevent freezing. Operate the washer switches periodically to check that the nozzles are clear and

© 2011-2024 Copyright www.rrevoque.org