Subaru Forester: Reclining the seatback (if equipped) - Rear seats - Seat, seatbelt and SRS airbags - Subaru Forester Owner's ManualSubaru Forester: Reclining the seatback (if equipped)

To prevent the passenger from sliding

To prevent the passenger from sliding under the seatbelt in the event of a collision, always put the seatback in the upright position while the vehicle is in motion. Also, do not place objects such as cushions between the passenger and the seatback. If you do so, the risk of sliding under the lap belt and of the lap belt sliding up over the abdomen will increase, and both can result in serious internal injury or death.

If the vehicle is equipped with a

If the vehicle is equipped with a cargo area cover, observe the following precautions.

- Be careful not to pinch your hand between the headrest and the cargo area cover when you recline the rear seat.

- Move the front cover of the cargo area cover backward so that the cover is not damaged by the reclined seatback. Refer to “Cargo area cover (dealer option)”.

Push the switch and adjust the seatback

Push the switch and adjust the seatback to the desired position.

Then release the switch and make sure the seatback is securely locked into place.

    Rear center seating position
    The head restraint is not intended to be used at the lowest position. Before sitting on the seat, raise the head restraint to an appropriate position depending on your sitting height. ...

    Folding down the rear seatback
    - When you fold down the seatback, confirm that there are no passengers or objects on the rear seat. Not doing so creates a risk of injury or property damage if the seatback suddenly f ...

    See also:

    Map lights
    Map lights Push the light lens to turn the map light on or off. The map light control switch has three positions: ON 1 , DOOR 2 and OFF 3 . The light 4 (if so equipped) will illuminate when t ...

    Rear combination lights
    1. Using a Phillips screwdriver, remove the upper and lower screws that secure the rear combination light assembly. 2. Slide the rear combination light assembly rearward and remove it from ...

    Anti-Pinch Protect Feature
    The Sky Slider™ will retract automatically if it detects an obstruction while closing. If this occurs, remove the obstruction and use the switch again to close the Sky Slider™. WARNING! T ...