Jeep Liberty: Rear Window Wiper/Washer
The rear wiper/washer is controlled by a rotary switch located on the control lever. The control lever is located on the right side of the steering column.
Rear Wiper/Washer Control
Rotate the switch upward to the first detent position for rear wiper operation.
NOTE: The rear wiper operates in an intermittent mode only.
Rotate the switch upward past the first detent to activate the rear washer. The washer pump will continue to operate as long as the switch is held (for a maximum of 10 seconds). Upon release, the wiper will cycle two times before returning to the set position.
If the rear wiper is operating when the ignition is turned OFF, the wiper will automatically return to the “park” position. When the vehicle is restarted, the wiper will resume function at whichever position the switch is set.
NOTE: The rear wiper and the rear washer will not operate If the liftgate flipper glass is open.
Rear Window Defroster
The rear window defroster button is located on the climate control (Mode) knob. Press this button to turn on the rear window defroster and the heated outside mirrors. An indicator in the butto ...See also:
Steep inclines and/or heavy loads
ACC is primarily intended for use on fairly level
roads. The system may have difficulty maintaining
the correct distance to a vehicle ahead
on steep inclines, if the vehicle is carrying a
heav ...
Seat belt pre-tensioners
The seat belt pre-tensioners activate in
conjunction with the SRS to provide additional
protection in the event of a severe frontal
impact. They automatically reduce any slack in
a seat belt to re ...
Low beams
When the engine is started, the low beams are
activated automatically (daytime running lights)
if the headlight control is in position 0 or
.
Daytime running lights can be deactivated in
the ...