Nissan Rogue: Programming trouble-diagnosis
If HomeLink® does not quickly learn the handheld
transmitter information:
- replace the hand-held transmitter batteries
with new batteries.
- position the hand-held transmitter with its battery area facing away from the HomeLink® surface.
- push and hold both the HomeLink® and hand-held transmitter buttons without interruption.
- position the hand-held transmitter 2 to 5 in (50 to 127 mm) away from the HomeLink® surface. Hold the transmitter in that position for up to 15 seconds. If HomeLink® is not programmed within that time, try holding the transmitter in another position - keeping the indicator light in view at all times.
If you continue to have programming difficulties, please contact the NISSAN Consumer Affairs Department. The phone numbers are located in the Foreword of this Owner’s Manual.
Operating the HomeLink® Universal Transceiver
HomeLink Universal Transceiver (once programmed)
may now be used to activate the
garage door, etc. To operate, simply push the
appropriate programmed HomeLink® Universal
Transceiver button. T ...
Clearing the programmed information
Individual buttons cannot be cleared, however to
clear all programming, push and hold the two
outside buttons and release when the indicator
light begins to flash (in approximately 20
seconds) ...
See also:
Sky Slider™ Full Length Open Roof — If Equipped
The Sky Sliderâ„¢ is a full-length, soft-top, power roof that
opens front to rear or rear to front. ...
Rear window wiper and washer
Type A
1 Intermittent window
wiper operation
2 Normal window
wiper operation
3 Washer/wiper dual
operation
4 Washer/wiper dual
operation
Type B
1 Intermittent window
wiper op ...
Emergency towing
Towing eyelet
Location of the towing eyelet
Attaching the towing eyelet ...
