Nissan Rogue: Clearing the programmed information - HomeLink® Universal Transceiver (if so equipped) - Instruments and controls - Nissan Rogue Owner's ManualNissan Rogue: Clearing the programmed information

Individual buttons cannot be cleared, however to clear all programming, push and hold the two outside buttons and release when the indicator light begins to flash (in approximately 20 seconds).

    Programming trouble-diagnosis
    If HomeLink® does not quickly learn the handheld transmitter information: - replace the hand-held transmitter batteries with new batteries. - position the hand-held transmitter with its batt ...

    Reprogramming a single HomeLink® button
    To reprogram a HomeLink® Universal Transceiver button, complete the following. 1. Push and hold the desired HomeLink® button. Do not release the button until step 4 has been completed. 2. Wh ...

    See also:

    Front airbag deployment
    • The front airbags are designed to deploy during certain frontal or front-angular collisions, impacts, or decelerations, depending on the crash severity, angle, speed and object impacted. T ...

    Tilt Steering Column
    This feature allows you to tilt the steering column upward or downward. The tilt control handle is located below the steering wheel at the end of the steering column. Tilt Steering Control Ha ...

    Brake fluid
    Location of the brake fluid reservoir Checking the level The fluid reservoir is concealed under the round cover at the rear of the engine compartment. The round cover must be removed first be ...