Volvo XC60: High/low beam headlights - High/low beam headlights - Lighting - Your driving environment - Volvo XC60 Owner's ManualVolvo XC60: High/low beam headlights

Continuous high beams

1. Set the ignition to mode II.

2. With the light switch in position 0 or the, pull the turn signal lever toward the steering wheel to position 2 to toggle between high and low beams (this also applies on models equipped with the optional Active Bending Lights).

> The symbol instrument panel to indicate that the illuminates in the instrument panel to indicate that the high beams are on.

    High beam flash
    Move the lever toward the steering wheel to position 1. The high beams come on until the lever is released. ...

    Low beams
    When the engine is started, the low beams are activated automatically (daytime running lights) if the headlight control is in position 0 or . Daytime running lights can be deactivated in the ...

    See also:

    Reset
    • press the button. • After the “Ready” prompt, and the following beep, say “Setup”, then “Reset”. This will delete all phone pairing, phone book entries, and other settings in ...

    If the wireless remote control does not operate
    Vehicles without smart key system Locking and unlocking the doors: Use the key Vehicles with smart key system Locking and unlocking the doors: Use the mechanical key. ...

    Add Names To Your Uconnect™ Phonebook
    NOTE: Adding names to the Uconnect™ Phonebook is recommended when the vehicle is not in motion. • Press the button to begin. • After the “Ready” prompt and the following beep, say “P ...