Subaru Forester: Daytime running light system (if equipped)
The brightness of the illumination of the high beam headlights is reduced by the daytime running light system.
The light switch must always be turned to the “” position when it is dark outside.
The high beam headlights will automatically
illuminate at reduced brightness
when the engine has started, under the
following conditions:
- The select lever is in a position other
than the “P” position (AT models).
- The parking brake is fully released.
- The light switch is in the “OFF” or “” position.
NOTE
When the light switch is in the “”
position, the front side marker lights,
tail lights and license plate lights are
also illuminated.
Headlight flasher
Headlight flasher To flash the headlights, pull the lever toward you and then release it. The high beam will remain on for as long as you hold the lever. The headlight flasher works even ...Automatic headlight beam leveler (models with HID headlights)
The HID headlights generate more light than conventional halogen headlights. Therefore a driver of an oncoming vehicle may experience too much glare when your headlight beam height adjustment ...See also:
Using the infotainment system
If the infotainment system is on when the ignition
is switched off, it will come on automatically
the next time the ignition is put in mode I
or higher and continue using the same source
(FM1, ...
Vehicle identification number (VIN)
The vehicle identification number (VIN) is the
number used in registering your car and in all
legal matters pertaining to its ownership, etc. It
can be found in three different places on your ...
Ignition mode functions
The various ignition modes are accessed with
the remote key in the ignition slot.
...