Toyota RAV4: Canceling and resuming the constant speed control
1 Pulling the lever toward you cancels the constant speed control.
The speed setting is also canceled when the brakes are applied.
2 Pushing the lever up resumes the constant speed control. Resuming is available when the vehicle speed is more than approximately 25 mph (40 km/h).
Adjusting the set speed
To change the set speed, operate the lever until the desired set speed is obtained. 1 Increase the speed 2 Decrease the speed Hold the lever until the desired speed setting is obtained. Fine a ...Cruise control can be set when
●The shift lever is in D or 3 (4-speed models), or D or 4 (5-speed models). ●Vehicle speed is above approximately 25 mph (40 km/h). ■Accelerating after setting the vehicle speed & ...See also:
Towing the Vehicle
Notice: To avoid damage, the disabled vehicle should be towed with all four wheels
off the ground. Care must be taken with vehicles that have low ground clearance
and/or special equipment. Always ...
Function
A vehicle towing a trailer may begin to sway for
various reasons. Normally this only occurs at
high speeds but, for example, if the trailer is
overloaded or if the load is unevenly distributed
...
Replacing tail/stop/turn/backup lamp bulbs
The tail/stop/turn/sidemarker/backup lamp bulbs are located in the same
portion of the tail lamp assembly, one just below the other. Follow the
same steps to replace either bulb:
1. Make sure the ...