Ford Escape: Replacing tail/stop/turn/backup lamp bulbs
The tail/stop/turn/sidemarker/backup lamp bulbs are located in the same portion of the tail lamp assembly, one just below the other. Follow the same steps to replace either bulb:
1. Make sure the headlamp switch is in the off position and then open the liftgate to expose the lamp assembly screws.
2. Remove the two screws from the
lamp assembly.
3. Carefully remove the lamp
assembly away from the vehicle by
pulling the assembly straight out to
expose the bulb socket. DO NOT
TIP THE LAMP ASSEMBLY SIDEWAYS.
4. Rotate the bulb socket counterclockwise and remove from lamp
assembly.
5. Pull bulb straight out of socket and push in the new bulb.
6. Install the bulb socket into the lamp assembly and rotate clockwise.
7. Carefully install the tail lamp assembly on the vehicle and secure with
two screws.
Replacing front sidemarker bulbs
For bulb replacement, see your authorized dealer. ...Replacing high-mount brake lamp bulbs
1. Remove the two screws and move the lamp assembly away from the liftgate. 2. Remove the bulb holder from the lamp assembly by pressing the snaps. 3. Pull the bulb straight out of the sock ...See also:
A/C Air Filter – If Equipped
Refer to the “Maintenance Schedule” for the proper
maintenance intervals.
WARNING!
Do not remove the A/C Air Filter while the blower is
operating or personal injury may result. ...
On-road and off-road driving
- In a rollover crash, an unbelted
person is significantly more
likely to die than a person wearing
a seat belt. You the driver and
all your passengers should fasten
the seatbelts before ...
Conditions in Which Remote Start Will Not Work
The remote vehicle start feature will not operate if:
○ The key is in the ignition.
○ The hood or doors are not closed.
○ The hazard warning flashers are on.
○ There is an ...