Jeep Liberty: Using Operator Mode
If the Sky Slider™ is open from the front, press the switch forward and hold it, the Sky Slider™ will move forward.
Release the switch to stop the Sky Slider™ travel at any point.
If the Sky Slider™ is open from the rear, press the switch rearward and hold it and the Sky Slider™ will move rearward. Release the switch to stop the Sky Slider™ travel at any point.
Using Automatic Mode
Press and release the button in the center of the switch and the Sky Slider™ will close automatically from any position. ...Manual Override
The Sky Slider™ drive motors are mounted to the roof above the cargo lamp. In the event that your vehicle losses battery power, you can close the Sky Slider™ by turning the drive gears in th ...See also:
Easy entry/exit
When Easy entry/exit is configured, the driver’s
seat will automatically lower when the ignition
is switched off and the door release lever is
used. Upon returning to the vehicle, when the
drive ...
Checking the fluid level when the fluid is cold
When the fluid level has to be checked
without time to warm up the automatic
transmission, check to see that the fluid
level is between the lower level and upper
level on the “COLD” range. ...
Reporting safety defects for U.S. owners
If you believe that your vehicle has a defect which could cause a
crash or could cause injury or death, you should immediately
inform the National Highway Traffic Safety Administration (NHTSA)
in a ...