Jeep Liberty: Manual Override - Closing The Sky Slider™ - Sky Slider™ Full Length Open Roof — If Equipped - Understanding The Features Of Your Vehicle - Jeep Liberty Owner's ManualJeep Liberty: Manual Override

The Sky Slider™ drive motors are mounted to the roof above the cargo lamp. In the event that your vehicle losses battery power, you can close the Sky Slider™ by turning the drive gears in the appropriate motor with a 6 mm Allen wrench. To do so, you must first remove the cargo lamp from the headliner. Then, insert the wrench into the “Allen” shaped hole in the appropriate motor and turn the wrench clockwise until the top closes completely. The left motor facing forward will close the top when it is open from the rear of the vehicle. The right motor will close the top when it is open from the front of the vehicle.

    Using Operator Mode
    If the Sky Slider™ is open from the front, press the switch forward and hold it, the Sky Slider™ will move forward. Release the switch to stop the Sky Slider™ travel at any point. If the S ...

    Anti-Pinch Protect Feature
    The Sky Slider™ will retract automatically if it detects an obstruction while closing. If this occurs, remove the obstruction and use the switch again to close the Sky Slider™. WARNING! T ...

    See also:

    Electric power steering system
    - If the engine is not running or is turned off while driving, the power assist for the steering will not work. Steering will be harder to operate. - When the electric power steering warni ...

    Canceling the function for meter/gauge needle movement upon turning on the ignition switch
    Type A Type B It is possible to activate or deactivate the movement of the meter needles and gauge needles that takes place when the ignition switch is turned to the “ON” position. ...

    Replacing high-mount brake lamp bulbs
    1. Remove the two screws and move the lamp assembly away from the liftgate. 2. Remove the bulb holder from the lamp assembly by pressing the snaps. 3. Pull the bulb straight out of the sock ...