Jeep Liberty: Using Automatic Mode
Press the switch rearward and release it within one-half second and the Sky Slider™ will open from the front and move automatically toward the rear of the vehicle.
Press the switch forward and release it within one-half second and the Sky Slider™ will open from the rear and move automatically toward the front of the vehicle.
NOTE:
• During operation, any movement of the Sky Slider™
switch will stop the Sky Slider™ roof.
• To resume the operation from a partially open position, press and release the switch a second time.
• The Sky Slider™ will not open from the front and the rear at the same time. The Sky Slider™ must close fully before opening it from the opposite end.
Using Operator Mode
Press the switch rearward and hold it, the Sky Slider™
will open from the front and move toward the rear of the
vehicle.
Press the switch forward and hold it, the Sky Slider™
will open from ...
See also:
Warnings and cautions
This Owner’s Manual contains WARNINGS against operating
procedures that could result in an accident or
bodily injury. It also contains CAUTIONS against procedures
that could result in damage t ...
Starting the Engine
Before Starting the Engine
1) Make sure the parking brake is set fully. 2) Manual Transmission – Shift into
“N” (Neutral) and depress the clutch pedal all the way to the floor. Hold it while ...
Restarting the tire pressure loss warning system
Restart the tire pressure loss warning system if you have:
changed the tire pressure
changed the wheels or tires
mount new wheels or tires
Before restarting, consult the Tire and Loading Inf ...